AMCOS AMAZER XTRA

Description

AMCOS AMAZER XTRA

About

AMCOS AMAZER XTRA is a high performance smooth exterior emulsion. It is formulated with good quality additives to protect from atmospheric conditions for long life. The special formula will give an XTRA life and protection to the walls.

Directions Of use

Mix well AMCOS AMAZER XTRA with water in recommended dilution ratio. Apply first coat and allow to dry for 4-6 hours. After complete drying, apply second coat of AMAZER XTRA and allow to dry.

Features

Water based

Good hiding

Good coverage

Good algal resistance

Packing

Colour

Recommended application method

Surfaces Preperation

Surface should be completely cured and free from dust, grease or loose particles. Any algal fungal growth should be properly removed and cleaned with bio wash to prevent the growth. Cracks should be properly sealed (Hairline cracks using AMCOS MASTER SEAL, cracks up to 2 mm using AMCOS SEAL AND FILL and cracks above 2 mm should be addressed by civil maintenance work). Ensure that the surface is prepared well before starting the application.
If an undulation free smooth finish is required, apply AMCOS SILKY FINISH WALL PUTTY as per the application procedure, allow to dry, sand and wipe clean to get a smooth finish.
Apply 1 coat of AMCOS PLASTER SEALER/ AMCOS WALL PRIMER EXTERIOR as per application procedure.

Technical Data

Dilution : 30-40% with clean and fresh water
Coverage : 150 – 160 sq. ft./ltr/coat
Surface dry : 45 minutes
Hard dry : 6 hours
Recoating interval : 12 hours
Gloss level : Matt

Safety

  • Wear masks, gloves, safety goggles and protective clothing while handling and application of paint.
  • Keep out of reach of children and away from eatables.
  • Store paints away from direct sunlight, heat open fire & water.
  • Do not pour the leftover paints in drains. Dispose off the paint left overs and containers as per local regulations.
  • Splashes on skin should be cleaned with a suitable solvent, washed off with soap and water.
  • ln case of any accidental ingestion or contact with eye, seek immediate medical attention.
  • Lead content does not exceed 90 ppm.

Disclaimer: The information contained with this datasheet is based on our laboratory and practical expiriments and we may change these with out notice. As the products are often used under conditions beyond our control, we do not take responsibility and liability for anything other than the quality of the product itself.

Points to Note